Digi TransPort LR54 - Show Digi Remote Manager Connection Status; Enable Health Reporting and Set Sample Interval

Remote management Remote Manager
Digi TransPort WR Routers User Guide
170
n Set the keepalive count. For example, to set it to 5:
digi.router> cloud keepalive-count 5
digi.router> save config
Show Digi Remote Manager connection status
Web
n On the menu, click System > Administration > Remote Manager.
The Digi Remote Manager page shows whether your device is connected to Digi Remote Manager, as
well as device connection statistics.
Command line
To show the status of the Digi Remote Manager connection, use the show cloud command.
In the show cloud command output, the device ID is the unique identifier for the device on the Digi
Remote Manager.
For example:
digi.router> show cloud
Device Cloud Status
-------------------
Status : Connected
Server : my.devicecloud.com
Device ID : 00000000-00000000-0040FFFF-FF0F4594
Uptime : 1 Minute, 9 Seconds
Received Sent
-------- ----
Packets 13 14
Bytes 37 218
digi.router>
Enable health reporting and set sample interval
You can enable the gathering of health metrics information for your device. Before enabling health
reporting, make sure you first register your device with Digi Remote Manager. For instructions, see
Configure Digi Remote Manager.
Web
1. From the menu, click System > Remote Manager.
2. Click Open Remote Manager.
3. Go to Configuration > Remote Manager page.
4. For the Enable health reporting option, select On.