Digi TransPort LR54 - Page 169

Remote management Remote Manager
Digi TransPort WR Routers User Guide
169
n If you have not already registered the device:
1. On the menu, click System > Administration > Remote Manager. The Digi Remote
Manager page appears.
2. Enter your credentials to log in to your Digi Remote Manager account and click Log In.
3. Select a group for you device in your Digi Remote Manager account, then click Register
Device.
4. If the registration succeeds, a message appears indicating that your device has been
registered in your Digi Remote Manager account; for example:
This device is registered in your Digi Remote Manager account
Group location: Group C
Optional: Modify Digi Remote Manager settings
1. On the menu, click System > Administration > Remote Manager.
2. Enter the settings.
n Enable or disable the TransPort device connection to Digi Remote Manager.
n Ethernet Keepalive: The interval between sending keepalives to Digi Remote Manager
over Ethernet interfaces.
n Cellular Keepalive: The interval between sending keepalives to Digi Remote Manager
over cellular interfaces.
n Reconnect Delay: The reconnection timer for reconnecting to Digi Remote Manager
after a disconnect. By default, the device attempts to connect to Digi Remote Manager
every 30 seconds.
3. Click Apply.
Command line
n Disable the Digi Remote Manager connection.
digi.router> cloud state off
digi.router> save config
n Set the reconnect timer. For example, to set it to 60 seconds:
digi.router> cloud reconnect 60
digi.router> save config
n Set the non-cellular keepalive time. For example , to set it to 180 seconds:
digi.router> cloud keepalive 180
digi.router> save config
n Set the cellular keepalive time. For example, to set it to 600 seconds:
digi.router> cloud keepalive-cellular 600
digi.router> save config