Digi TransPort LR54 - Debug an Openvpn Tunnel

Virtual Private Networks (VPN) OpenVPN
Digi TransPort WR Routers User Guide
218
1 Up 203.0.113.3 10.8.0.2 255.255.255.0 VPN connection
to main office
digi.router>
Display detailed status information for an OpenVPN client
Enter the show openvpn-client x command, where x is the index number of the client, from the first
column of summary show openvpn-client command output. For example:
digi.router> show openvpn-client 1
OpenVPN Client Status
---------------------
Description : VPN connection to main office
Admin Status : Up
Oper Status : Up
Remote Server : 203.0.113.3
Interface : ovpn1
IP Address : 10.8.0.2
Mask : 255.255.255.0
MTU : 1500
Received Sent
-------- ----
Interface Packets : 13 9
Interface Bytes : 940 684
Socket Bytes : 5201 4908
digi.router>
Debug an OpenVPN tunnel
You can enable debugging on an OpenVPN server or on a specific OpenVPN client. When enabled,
debugging messages display in the system log.
Enabling debugging is done by changing the logging level for messages on the OpenVPN server and
the OpenVPN client. There are four logging levels, from 0 to 4. Set this parameter to 0 to record only
errors and warnings, and set it to 4 to record fairly complete log activity to help debug an OpenVPN
tunnel.
Web
1. On the menu, click Network > Networks > OpenVPN > Server.
The OpenVPN Server page appears.
2. Click Edit.
3. Set the Logging Level to 3.
4. Click Apply.
5. On the menu, click Network > Networks > OpenVPN > Client.
The OpenVPN Client page appears.
6. Select the OpenVPN client to configure.
7. Set the Logging Level to 3.
8. Click Apply.