Digi TransPort LR54 - Page 313

Web reference Location Client page
Digi TransPort WR Routers User Guide
313
Configuration options
Option Description
Description (Optional) Enter a description of the location client.
Server
The IP address of the remote host to which location messages will be sent.
Server Port
The UDP port on the remote host to which location messages will be sent.
Type
The protocol type for the messages, either
TAIP
or
NMEA
.
TAIP/NMEA
Filter
The types of messages that will be forwarded. Allowed values depend on the protocol
type selected for Type:
n If the protocol type is TAIP, allowed values are:
l AL — Reports altitude and vertical velocity.
l CP — Compact position: reports time, latitude, and longitude.
l ID — Reports the vehicle ID.
l LN — Long navigation: reports the latitude, longitude, and altitude, the
horizontal and vertical speed, and heading.
l PV — Position/velocity: reports the latitude, longitude, and heading.
The default is to report all message types.
n If the protocol type is NMEA, allowed values are:
l GGA — Reports time, position, and fix related data.
l GLL — Reports position data: position fix, time of position fix, and status.
l GSA — Reports GPS DOP and active satellites.
l GSV — Reports the number of SVs in view, PRN, elevation, azimuth, and
SNR.
l RMC — Reports position, velocity, and time.
l VTG — Reports direction and speed over ground.
The default is to report all message types.
Prepend (Optional) Text to prepend to the forwarded message. Two variables can be included
in the prepended text:
n %s — Includes the TransPort device's serial number in the prepended text.
n %v — Includes the vehicle ID in the prepended text. See Configure the Vehicle
ID for information about configuring the vehicle ID.