Digi TransPort LR54 - Page 112

Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
112
d. Configure the default IP address and subnet mask for the hotspot. The IP address
and subnet mask define the subnet that will be used by the hotspot's DHCP server.
See Hotspot DHCP server for more information.
digi.router> hotspot ip-address ip-address
digi.router> hotspot mask subnet-mask
e. (Optional) Change the hotspot server port. Default is 4990.
digi.router> hotspot server-port port
f. (Optional) Change the port that the hotspot uses for authentication. Default is
3990.
digi.router> hotspot auth-port port
g. (Optional) Change the upload and download throughput limits, in kbps, that will be
applied to clients that connect to the hotspot. The default for both is 10000 kbps.
digi.router> hotspot bandwidth-max-up max_in_kbps
digi.router> hotspot bandwidth-max-down max_in_kbps
h. (Optional) Change the duration of the DHCP server lease in seconds. The default is
600 seconds.
digi.router> hotspot dhcp-lease length_in_seconds
i. Enable the hotspot.
digi.router> hotspot state on
2. Enable and add interfaces to the hotspot's LAN:
a. Enable the LAN:
digi.router> lan 3 state on
b. Add interfaces to the LAN:
digi.router> lan 3 interfaces wifi-ap2
3. Configure the Wi-Fi interface:
Note If an Ethernet interface was added to the LAN, no configuration of the Ethernet interface
is required.
a. Set the SSID for the Wi-Fi interface:
digi.router> wifi-ap 2 ssid ssid
b. Disable the Wi-Fi interface's security:
digi.router> wifi-ap 2 security none