Digi TransPort LR54 - Page 116

Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
116
Web
1. Enable and configure the hotspot for RADIUS shared password authentication:
a. On the menu, click Network > Services > Hotspot.
b. Click Enable to enable the hotspot.
c. For LAN, select a LANfor the hotspot. See Hotspot LANconfiguration for important
information about selecting a LANfor the hotspot.
d. For Login, select the login type:
n Local Page—Uses an HTMLpage for authentication that is stored locally on
the TransPort device's filesystem, in the hotspot directory. Note that the
hotspot directory is not visible until hotspot has been enabled for the first
time.
n Remote URL—Uses an HTML page for authentication that is served by a
remote web server.
e. Local Page/Remote URL:
n If Local Page is selected for the Login type, the Local Page field is
displayed. Normally, this field should be left blank, and the TransPort device
will use the default authentication HTMLpage (for RADIUS shared password
authentication, the default authentication page is password.html). If you
upload a custom HTML file that uses a filename other than the default
filename, you should select the custom filename here. See Upload custom
hotspot HTML pages for more information about creating and uploading
custom HTML files.
n If Remote URL is selected for the Login type, enter the URL in the Remote
URL field. The URL must begin with http:// or https://. The server listed
here must also be included in the Allowed Domains or Allowed Subnets.
f. For IP Address, enter the IP address for the hotspot's LAN. The default is 10.1.0.1.
This IP address also defines the subnet that will be used by the hotspot's DHCP
server. See Hotspot DHCP server for more information.
g. For Subnet Mask, enter the subnet mask for the hotspot's LAN. The default is
255.255.255.0.
h. For Auth Mode, select RADIUS Shared Password.
i. For Primary RADIUS Server, enter the IP address or fully-qualified domain name of
the RADIUS server to use to authenticate hotspot users.
j. For RADIUS Server Secret, enter the shared secret for the RADIUS server. This is
configured on the RADIUS server.
k. For RADIUS NAS ID, enter the NAS ID. The default is hotspot.
l. Click Advanced.
Many of the advanced hotspot settings are optional or contain default values that
normally do not need to be changed.
m. For Server Port, enter the port number for the hotspot server. The default is 4990.
n. For Auth Port, enter the port number for the hotspot authentication server. The
default is 3990.