Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
118
a. On the menu, click Network > Interfaces > Wi-Fi.
n If the access point selected as the Wi-FI interface for the hotspot's
LANalready exists, select that access point.
n If the access point selected as the Wi-FI interface for the for the hotspot's
LANdoes not exist
i. Click New Access Point.
ii. For Select Access Point, select the access point of the Wi-FI
interface that was selected for the LAN.
b. For SSID, type the SSID that will be used for this hotspot.
c. For Security, select None.
d. Enable Broadcast SSID.
e. Click Apply.
Command line
1. Enable and configure the hotspot for RADIUS shared password authentication:
a. Assign the appropriate LAN to the hotspot:
digi.router> hotspot lan lan3
See Hotspot LANconfiguration for important information about selecting a LANfor
the hotspot.
b. Set the authentication mode to radius-shared-password:
digi.router> hotspot auth-mode radius-shared-password
To Next Page
Loading...
