Digi TransPort LR54 - Page 121

Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
121
q. Enable the hotspot.
digi.router> hotspot state on
2. Enable and add interfaces to the hotspot's LAN:
a. Enable the LAN:
digi.router> lan 3 state on
b. Add interfaces to the LAN:
digi.router> lan 3 interfaces wifi-ap2
3. Configure the Wi-Fi interface:
Note If an Ethernet interface was added to the LAN, no configuration of the Ethernet interface
is required.
a. Set the SSID for the Wi-Fi interface:
digi.router> wifi-ap 2 ssid ssid
b. Disable the Wi-Fi interface's security:
digi.router> wifi-ap 2 security none
4. Save the configuration:
digi.router> save config