Digi TransPort LR54 - Page 128

Hotspot Hotspot configuration
Digi TransPort WR Routers User Guide
128
f. (Optional) Set the fully qualified domain name or IP address of the secondary
RADIUS server, used if the primary RADIUS server is unreachable:
digi.router> hotspot radius-server2 server
g. Set the shared secret for the RADIUS server. This is configured on the
RADIUSserver.
digi.router> hotspot radius-secret secret
h. Set the RADIUS server NAS ID. The default is hotspot.
digi.router> hotspot radius-nas-id nas-id
i. (Optional) change the UDP port number for the RADIUS server. The default is 1812.
digi.router> hotspot radius-server-port port
j. (Optional) Enable Swap Octets to swap the meaning of the input octets/packets
and output octets/packets RADIUS attributes. This can fix issues if the data limits
and/or accounting reports appear to be reversed on the RADIUS server. The default
is disabled.
digi.router> hotspot swapoctets on
k. (Optional) Enable the use of a UAMsecret if required for integration with a cloud
hotspot provider.
digi.router> hotspot use-uamsecret on
l. For UAM Secret, if the use of a UAM secret is enabled, enter the UAMsecret.
digi.router> hotspot uamsecret secret
m. (Optional) Change the hotspot server port. Default is 4990.
digi.router> hotspot server-port port
n. (Optional) Change the port that the hotspot uses for authentication. Default is
3990.
digi.router> hotspot auth-port port
o. (Optional) Change the upload and download throughput limits, in kbps, that will be
applied to clients that connect to the hotspot. The default for both is 10000 kbps.
digi.router> hotspot bandwidth-max-up max_in_kbps
digi.router> hotspot bandwidth-max-down max_in_kbps
p. (Optional) Change the duration of the DHCP server lease in seconds. The default is
600 seconds.
digi.router> hotspot dhcp-lease length_in_seconds