Digi TransPort LR54 - Page 143

Services and applications Location information
Digi TransPort WR Routers User Guide
143
Required configuration items
n Enable the location server.
n UDP port that the TransPort device will listen to for incoming location messages. If set to 0,
the location feature is disabled.
n An IP filter rule that allows incoming messages from external sources to the specified port.
Additional configuration items
n Refresh interval, in seconds. Determines how often the device will poll the specified UPD port
for incoming location messages. Accepted value is any integer from 1 to 3600; the default is 10.
Configure the listening port
Web
1. On the menu, click System > Configuration > Location > Settings.
2. Set the GNSS State toggle switch to Server.
3. For Server Port, set the port that will receive incoming location messages.
4. (Optional) For Interval, set the refresh interval.
5. Click Apply.
Command line
To enable the GNSSmodule:
To configure the TransPort device to accept incoming location messages:
1. Enable the location server:
digi.router> location state server
2. Set the port that will receive incoming location messages:
digi.router> location server-port 8000
3. (Optional) Set the refresh interval:
digi.router> location interval 5
4. Save the configuration:
digi.router> save config
Create IP filter rule
An IP filter rule must be created for the port that will receive incoming location messages. This
procedure can be performed from either the WebUI or the command line.
Web
1. On the menu, click Security > Firewall > Input IPFilters.
2. Click  (Add Filter) to create a new filter.