Digi TransPort LR54 - Page 146

Services and applications Location information
Digi TransPort WR Routers User Guide
146
7. For Type, select the protocol type for the messages, either TAIP or NMEA.
8. (Optional) Select the types of messages that will be forwarded. Allowed values depend on the
protocol type selected for Type:
n If the protocol type is TAIP, allowed values are:
l AL — Reports altitude and vertical velocity.
l CP — Compact position: reports time, latitude, and longitude.
l ID — Reports the vehicle ID.
l LN — Long navigation: reports the latitude, longitude, and altitude, the horizontal
and vertical speed, and heading.
l PV — Position/velocity: reports the latitude, longitude, and heading.
The default is to report all message types.
n If the protocol type is NMEA, allowed values are:
l GGA — Reports time, position, and fix related data.
l GLL — Reports position data: position fix, time of position fix, and status.
l GSA — Reports GPS DOP and active satellites.
l GSV — Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
l RMC — Reports position, velocity, and time.
l VTG — Reports direction and speed over ground.
The default is to report all message types.
9. (Optional) For Prepend, enter text to prepend to the forwarded message. Two variables can
be included in the prepended text:
n %s — Includes the TransPort device's serial number in the prepended text.
n %v — Includes the vehicle ID in the prepended text. See Configure the Vehicle ID for
information about configuring the vehicle ID.
For example, to include both the device's serial number and vehicle ID in the prepend message,
you can enter the following in the Prepend field:
__|%s|__|%v|__
10. Click Apply.
Command line
1. Enable the location feature:
n To forward the device's location information based on its GNSSmodule:
digi.router> location state gnss
n To forward location information from external sources:
digi.router> location state server
2. Set the IP address of the remote host to which location messages will be sent:
digi.router> location-client 1 server 192.168.2.3