System settings System date and time
Digi TransPort WR Routers User Guide
236
n To display detailed status and statistics for the NTP server configuration:
digi.router> show ntp
NTP Server
----------
Admin Status : Up
Sync Status : In Progress
Interfaces : lan1,lan2
Remote Refid St T When Poll Reach Delay Offset Jitter
---------------------------------------------------------------------------
*ec2-52-2-40-158 129.6.15.32 2 u 62 64 17 9.797 0.396 10.942
+time.deviceclou GOOG. 1 u 62 64 17 24.576 1.171 9.514
digi.router>
Where:
l Admin Status — Indicates whether the NTP server is sufficiently configured to be
functional.
l Sync Status — Indicates whether the NTP server has successfully synced with an
upstream peer.
l Interfaces — Lists the LAN interfaces that the NTP server is serving.
l Remote — URL of NTP peer from reverse DNS lookup. The URL is preceded by a special
character, called the "tally code," which represents the current state of the NTP peer:
o
space character — The server is not being used (the server may be unreachable, forms a
synchronization loop with the TransPort device, or there is too much distance for
accurate synchronization).
o
x — The NTPserver is not being used (falseticker).
o
. — The NTPserver is not being used (sync distance).
o
- — The NTPserver is not being used (outlier).
o
+ — The NTPserver is a candidate for the combining algorithm.
o
# — The NTPserver could be used.
o
* — The NTPserver is NTP system peer.
o
o — The NTPserver is NTP system peer (pulse-per-second (PPS) signal).
l Refid — Reference ID for the peer's source of time.
l St — Stratum or steps from reference clock.
l T — Type of addressing used:
o
l — local
o
u — unicast
o
m — multicast
o
b — broadcast
o
– — netaddr
l When — Number of seconds since last response.
To Next Page
Loading...
