Diagnostics and troubleshooting Troubleshooting
Digi TransPort WR Routers User Guide
278
2. Open the command line interface. Enter the command lan n, where n is the number of the LAN
with which the Ethernet port is associated. In the command output, verify that the Ethernet
port really is assigned to the LAN. For example, if the port is supposed to be associated with
LAN 1, enter:
digi.router> lan 1
description Ethernet and Wi-Fi LAN network
dhcp-client off
dns1
dns2
interfaces eth2,eth3,eth4,wifi1,wifi5g1
ip-address 192.168.1.1
mask 255.255.255.0
mtu 1500
state on
3. If the Ethernet port is not listed as one of the LAN’s interfaces, add it using the command lan n
interfaces, where n is the Ethernet port number.
4. Verify that the LAN is enabled. If needed, enter the command lan n state on to enable the LAN.
digi.router> lan 1
description Ethernet and Wi-Fi LAN network
dhcp-client off
dns1
dns2
interfaces eth2,eth3,eth4,wifi1,wifi5g1
ip-address 192.168.1.1
mask 255.255.255.0
mtu 1500
state on
5. Verify that the LAN is configured with an IP address. Use the lan n ip-addresscommand to set
the IP address if necessary.
digi.router> lan 1
description Ethernet and Wi-Fi LAN network
dhcp-client off
dns1
dns2
interfaces eth2,eth3,eth4,wifi1,wifi5g1
ip-address 192.168.1.1
mask 255.255.255.0
mtu 1500
state on
To Next Page
Loading...
