Digi TransPort LR54 - Page 292

Web reference Firewall page
Digi TransPort WR Routers User Guide
292
Routing IPfilter options
Option Description
Enabled Enables or disables the IP filter rule. The default is enabled.
Description Description for the rule. Specify a string value up to 255 characters long.
Action Specifies what to do with received packets: Accept, Drop, or Reject packets. The
default is Accept.
Src Specifies the interface for the incoming packets: ANY-LAN, ANY-WAN, or a specific
LAN or WAN. The default is NONE.
Address Specifies the source IPaddress for incoming packets. If you do not specify an address,
the filter is applied to all addresses. Specify the IP address in IPv4 or IPv6 format. The
format for the source IP address and the destination IPaddress must match. To force
either IPv4 or IPv6 version, enter a default address:
n For IPv4
0.0.0.0/0
n For IPv6
::/0
Port
Specifies the source port number. You can enter a port number, a range of ports, or a
list of ports. If you do not specify a port, the filter is applied to all ports.
Dest Specifies the destination interface for forwarded packets: ANY-LAN, ANY-WAN, or a
specific LAN or WAN.
Address Specifies the destination IPaddress for incoming packets. If you do not specify an
address, the filter is applied to all addresses. Specify the address in IPv4 or IPv6
format. The format for the source IP address and the destination IPaddress must
match. To force either IPv4 or IPv6 version, enter a default address:
n For IPv4
0.0.0.0/0
n For IPv6
::/0
Port
Specifies the destination port number. You can enter a port number, a range of ports,
or a list of ports. If you do not specify a port, the filter is applied to all ports.
Protocol Specifies the protocol for incoming packets: tcp, udp, and icmp. If you do not specify a
protocol, the filter is applied to all protocols.