Digi TransPort LR54 - Page 307

Web reference IPsec Tunnels page
Digi TransPort WR Routers User Guide
307
IPsec Tunnels page
Use the IPsec Tunnels page to configure IPsec tunnels. You can configure up to 32 tunnels.
Network options
Option Description
Description Description for the IPsec tunnel. Specify a string value up to 255
characters long.
Enable Enables or disables the IPsec tunnel. The default is enabled.
Local IP network Specifies the local network IP address for this IPsec tunnel. Enter an
IPv4 address.
Local identifier Specifies the local ID used for this IPsec tunnel. Enter a string up to 31
characters long.
Remote peer IPaddress
or name
Specifies the remote peer for this IPsec tunnel. Enter a fully qualified
domain name.
Remote IPnetwork
Specifies the remote network IP address for this IPsec tunnel. Enter
an IPv4 address.
Remote IPnetwork mask
Specifies the remote network mask for this IPsec tunnel. Enter an
IPv4 address.
Remote identifier
Specifies the remote ID used for this IPsec tunnel. Enter a string up to
31 characters long.
Authentication
Option Description
Authentication
Mode
The type of authentication to be used for the IPsec tunnel. Available options are
Pre-shared Key Authentication or XAuth and Pre-shared Key Authentication.
IPsec pre-
shared key
Specifies the preshared key for the IPsec tunnel. Enter a string up to 128
characters long.
XAuth Role Determines whether the device will function as an XAuth client or server. Values
are:
n Client Role — Device will function as an XAuth client.
n Server Role — Device will function as an XAuth server. If this is selected,
you need to create XAuth users at the IPsec XAuth Users page (Network >
Networks > IPsec > Users).
XAuth Identity
If
Client Role
is selected for
XAuth Role
, enter the username to use for XAuth
authentication.
XAuth
Password
If
Client Role
is selected for
XAuth Role
, enter the password to use for XAuth
authentication