Digi TransPort LR54 - Page 319

Web reference New Wide Area Network (WAN) page
Digi TransPort WR Routers User Guide
319
Option Description
Security
Allow
HTTPS
Enable or disable HTTPS access for the WAN. The default is Disabled.
Allow SSH
Enable or disable SSH access for the WAN. The default is Disabled.
Probing
Probe
host
Specifies the IPv4 or fully qualified domain name (FQDN) of the address of the device
itself. The WAN failover feature sends probe packets over the WAN to the IP address of
this device. Value should be a fully qualified domain name.
Probe
interval
Specifies the interval, in seconds, between sending probe packets. The value for must
be larger than the Probe timeout value. If not, the WAN failover configuration is
considered invalid, and an error message is written to the system log. Accepted value
is any integer from 2 to 3600. The default value is 60.
Probe size
Specifies the size of probe packets sent to detect WAN failures. Accepted value is any
integer from 64 to 1500. The default value is 64.
Probe
timeout
Specifies the timeout, in seconds, to wait for a response to a probe. The value for this
parameter must be smaller than the Probe interval and timeout parameter values or
the configuration is considered invalid, and an error message is written to the system
log. Accepted value is any integer from 1 to 60. The default value is 5.
Activate
after
Specifies the time, in seconds, that the primary interface needs to be up before
switching back to it as the active interface. If probing is active, no probes are
permitted to be lost during this period. Otherwise, the timer is restarted. Accepted
value is any integer from 0 to 3600. The default value is 0.
Retry
after
Specifies the time, in seconds, to wait before retrying this interface after failing over to
a lower priority one. Use a large retry timeout when both interfaces are cellular
interfaces. Accepted value is any integer from 10 to 3600. The default value is 180.
Timeout
Specifies the time, in seconds, to wait for the physical interface to connect and to
receive a probe response before failing over to a lower priority interface. Accepted
value is any integer from 10 to 3600. The default value is 180.
Status display
Option Description
Interface
Shows the interface for the WAN.
Admin status
Shows the administrative status for the WAN: Up or Down.
Oper status
Shows the operational status for the WAN: Up or Down.
IP address
Shows the IP address for the WAN.
Netmask
Shows the Netmask for the WAN.
Gateway
Shows the Gateway for the WAN.