Digi TransPort LR54 - Page 8

Digi TransPort WR Routers User Guide
8
Configure a Python application to run automatically at startup 153
Digidevice module 155
Log messages for Python applications 157
Port forwarding 158
Add a port forwarding rule 158
Delete a port forwarding rule 159
Enable or disable a port forwarding rule 159
Show port forwarding rules 160
Using an SSH server 160
Configure a Secure Shell (SSH) server 160
Use SSHto connect to the TransPort command-line interface 160
Terminate an SSH connection 161
Using SSH with key authentication 161
Using SSH with certificate authentication 162
Example: Use an SSL certificate authentication 164
Example: Use an SSL certificate authentication with shared account 165
Remote management
Remote Manager 168
Configure Digi Remote Manager 168
Show Digi Remote Manager connection status 170
Enable health reporting and set sample interval 170
Using Simple Network Management Protocol (SNMP) 171
Configure SNMPv1 and SNMPv2 172
Configure SNMPv3 172
Routing
IP routing 175
Configure general IP settings 175
Configure a static route 176
Show the IPv4 routing table 177
Delete a static route 177
Routing rules 178
Dynamic DNS 180
Configure dynamic DNS 180
Web filtering (OpenDNS) 181
Configure web filtering using Cisco Umbrella 181
Clear device ID 182
Dynamic Mobile Network Routing (DMNR) 182
Configure Verizon DMNR 182
Show DMNR status 183
Quality of Service (QoS) 184
Configure QoS 184
Show QoS configuration and status 186
Virtual Router Redundancy Protocol (VRRP) 187
Configure VRRP protocol 187
Show VRRP status and statistics 189
Virtual Private Networks (VPN)
IPsec 191