To Next Page

To Previous Page

284 Eos Family Operations Manual

Go From Last

Go From Last controls the behavior that happens when you press the [Go] button while in the last

cue.

The following are Go From Last options:

Do Nothing (Default Setting) - keeps the last cue in the list active.

Cue Out - only fades out channels in that cue list. Other channels will remain. Intensity levels

will go out. Non-intensity parameters will remain. This setting uses the Go to Cue timing for

fading.

Wrap - puts the first cue into pending, and fires it.

RestoreBackground - any background cue, submaster, and effect levels are restore following

background priority. Manual levels will not be restored. This setting uses the Release time. The

pending cue will be set to the first cue in the list. If there is no background state, the non-

intensity parameters will not fade.

Stomp Mode

Stomp refers to when all the content owned by a cue is now being controlled by other targets. The

cue is being removed from the background, and once that happens, it would not be eligible to fade

back. You can assign behavior that will happen when a cue is stomped.

The following are Stomp Mode options:

Off When Stomped - puts the content into an off state, the same behavior encountered when

pressing [Off] + [Load].

Unload When Stomped - unloads the fader.

Nothing When Stomped (Default Setting) - nothing happens.

Release When Stomped - resets a cue list to the top of the list.

Exclusions

Those exclusions include:

Exclude From Record - output is not recorded into any other record target.

Exclude From Grandmaster - content cannot be mastered by a grandmaster.

Exclude From InhibitiveSub - content cannot be mastered by an inhibitive submaster

Exclude From Solo - content will ignore solo button mode. See Fader and Button Con-

figuration (on thefacing page) for more information on solo.

Channel and Parameter Filters

Channel and Parameter Filters can be used to allow only specified data to be played back. These are

playback filters, and do not impact how data is recorded.

For cue lists, channel and parameter filters can be set in the following areas:

Cue List Index using the {Properties} softkey

In Fader Configuration (Tab 36)

In Live using the {Properties} softkey

ETC Element 2 Operating Manual

Other manuals for ETC Element 2