ETC Element - Page 153

Setup 141
Delete Confirm
This field allows you to enable/ disable a required confirmation before any delete command is
executed. The default is “Enabled”.
Auto Playback
When enabled, this feature automatically plays back cues and submasters as they are stored
and releases manual control. For submasters to automatically play back, the slider must be at
full. This field is a toggle state between “Enabled” and “Disabled”. When auto playback is
“Disabled”, all manual levels are maintained and cues must be loaded and executed on
playbacks. The default is “Enabled”.
Update Mode
This field allows you to select a default update mode (see Update Dialogue Box (on page234) ).
The default is “Make Absolute”.
Break Nested
This setting allows you to enable/ disable the update modifier break nested. The default is
“Enabled”.
Update Last Ref
This setting allows you to enable/ disable the update modifier update last ref. The default is
“Enabled”.
Manual Control
This user setting button gives you access to manual control settings.
Manual Time
In this section you may change the default times for manual changes to occur in live. Times can
be set for each parameter category (Intensity Up, Intensity Down, Focus, Color, and Beam). You
may use the [Thru] key to enter a value for all categories.
•
{Int Up} [Thru] [9] [Enter]
The default for each of these is 0 seconds.
Manual Control
This section allows you to specify the values for certain buttons or settings used in manual
control. To change any value, touch the appropriate button in the CIA and use the keypad to
enter a new value. Fields are:
•
Level - This sets the value for the [Level] key. Any value between 0-100 may be entered.
The default is 80.
•
Plus% - This sets the level for the [+%] key, which will increase the selected channel by
the set percentage. You can assign +% to values that have up to five digits. The default is
10%.
•
Minus% - This sets the level for the [-%] key, which will decrease the selected channel by
the set percentage. You can assign -% to values that have up to five digits. The default is
10%.
•
Highlight Preset - This field is used to specify the preset that will be used for any highlight
commands.
•
Lowlight Preset - This field is used to specify the preset that will be used for any lowlight
commands.