ETC Element - Selecting Groups; Opening the Group List

182 Eos Family v2.9.0 Operations Manual
You can also use the {Offset} softkeys to aid in create of groups and subgroups. See Offset (on
page179) for more information.
Selecting Groups
Groups may be selected from the control keypad or the direct selects.
To select a group:
•
[Group] [1] [Enter] - selects all channels in Group 1
•
[Group] [1] [At] [5] <0> [Enter] - selects Group 1 and places all channels within at 50%
•
{Group 1} - Selects all channels in Group 1
If [Next] is used after a group selection, it accesses the first ordered channel in that group.
Pressing it again accesses the second ordered channel in that group, and so on. [Next] - used
after the last channel in the group - accesses the first channel in the group again.
[Last] may be used with group selects similar to [Next]. Press [Select Last] to reselect the entire
group.
Deleting Groups
When you delete a group, the group number and all contents from the Group List Index and
Direct Selects are deleted. Delete commands require a confirmation by default. This can be
altered in the default settings. If you disable confirmations, the second enter is not required in
the following examples:
Group deletion features include:
•
[Delete] [Group] [5] [Enter] [Enter] - deletes group 5.
•
[Delete] [Group] [3] [+] [Group] [5] [Enter] [Enter] - deletes groups 3 and 5.
•
[Delete] [Group] [3] [Thru] [9] [Enter] [Enter] - deletes groups 3 through 9.
•
[2] [Delete] [Group] [7] [Enter] - deletes channel 2 from group 7.
Opening the Group List
The group list allows viewing and editing of groups.
To open the group list you can:
•
Press [Group] [Group]
•
Press [Tab] [1] [7]
You can navigate within the group list using [Next] and [Last] or by selecting the group you want
to work with.
Ordered View and Numeric View
By default, grouped channels will be displayed in ordered view. Therefore, grouped channels
will appear in the order they were added to the group (see Ordered Channels (on page178) ). If
you wish to view the channels in numeric view, press the [Format] key and the view will be