ETC Element - Creating and Using Effects

Cue Playback 267
•
Time
•
[Go to Cue] [5] [Time] [Enter] will go to cue 5 using cue times, and also uses any
associated follow/hang times to automatically trigger the subsequent cue. To go to a cue
in cue time, but not trigger the follow/hang, you would use [Go to Cue] [5] {Minus Links}
[Time] [Enter].
Note: If you want to specify a time or use the cue time, the [Time] command must
always be entered after any other commands, such as {Minus Links} or {SingleParam}.
The exception to this rule is {Manual}.
These can be combined within the command line as well:
•
[Go To Cue] [1] {MultiParam} {MovesOnly} [Enter]
Virtual Faders
You can have access to additional faders by using the virtual faders (see Virtual Fader Module
(on page66) ).
Changing Fader Pages
OnElement, you can page the faders by holding down the {Page Subs} softkey in the Live
display. The bump buttons will light up in green, and the bump buttons that correspond to the
currently selected pages will flash. Press the corresponding bump button to go to that page. The
fader status display will change to show the fader pages. See Paging Submasters (on page308)
for more information.
Playback Fader Controls
In Element, many of the buttons mentioned below exist as softkeys. In order to have access to
some of these keys, press [Live] {Fader Control}. The softkeys will change to display the fader
control keys. You may press [More SK] if the green LED is illuminated, to view additional fader
control buttons.
The following controls are available:
•
Load ( Selected Cue (on page264) )
•
Go ( Using [Go] (on the next page) )
•
Stop/ Back ( Using [Stop/ Back] (on the next page) )
•
Blackout ( Using Blackout and Grandmaster (on the next page) )
•
Grandmaster ( Using Blackout and Grandmaster (on the next page) )
•
Go To Cue 0 ( [Go To Cue] [0] (on the next page) )
•
Assert ( Using Assert (Playback Button) (on the next page) )
•
Timing Disable ( Using Timing Disable (on the next page)
•
Freeze Using Freeze (on page269) )
•
Stop Effect ( Using Stop Effect (on page269) )
•
Rate Override ( Using Rate Override (on page269) )
•
Manual Override ( Manual Override (on page271) )
•
Off ( Releasing Content From a Fader (on page271) )
•
Release ( Releasing Content From a Fader (on page271) )
•
Fader Page ( Changing Fader Pages (above) )