ETC Element - Page 278

266 Eos Family v2.9.0 Operations Manual
•
[Go To Cue] [2] [Time] [1] [Enter] - this command would take you to cue 2 in one second.
•
[Go To Cue] [3] [Time] [4] [/] [3] [Enter] - this command would take you to cue 3 and all
up fades and NP moves would have a time of four seconds and down fades of 3.
•
[Go to Cue] [Next] [Time] [3] [Enter] - this command would take you to the next cue in the
selected list in three seconds.
•
[Go to Cue] [Last] [Time] [2] [Enter] - this command would take you to the previous cue in
the selected list in two seconds.
•
[Go To Cue] [8] [Time] [Enter] - this command would take you to cue 8 using all timing
values stored in cue 8.
Other Go To Cue Options
When [Go to Cue] is pressed, the softkeys in the CIA change to provide Go to Cue modifiers to
enhance your playback ability.
From these softkeys, you can specify that when going to a cue, only some elements of that cue
will be played back. Specifically you can choose to play back:
•
Manual control using a fader
•
[Go to Cue] [6] {Manual} [Enter]
•
Scenes opens the Scenes (on page229) selection display.
•
[Go To Cue] {Scenes} - press or select a scene to go to that cue.
•
Move instructions only
•
[GoTo Cue] [3] {MovesOnly} [Enter]
•
Withhold any links (follow, hang, execute instructions)
•
[GoTo Cue] [4] {MinusLinks} [Enter]
•
Complete a cue
•
[Go To Cue] [4] {Complete} [Enter] will go to cue 4 and if that cue has a follow/ hang, any
following cues in the sequence will also fire. This may look like you are going straight to
the last cue in the sequence but each cue will fire to make sure that any external links are
fired.
•
[Go To Cue] [2] [At] [5][0] {Complete} [Enter] will go to cue 2 at 50% of its completion.
•
[Go to Cue] [5] [Time] [Go to Cue] will go to cue 5 using cue times, and append
[Complete] to the command line.
•
Single parameter channels only (conventionals)
•
[GoTo Cue] [1] {SingleParam} [Enter]
•
Multiple parameter channels only (moving lights)
•
[GoTo Cue] [2] {MultiParam} [Enter]
Note: Double pressing [Go To Cue] will post Go ToCue Complete to the command
line. You can then select the appropriate cue number and level of completion.
The following are additional modifiers that can be used with [Go To Cue]:
•
Homes a cue list to its first cue
•
[Go to Cue] {Home} [Enter] homes the currently selected cue list to its first cue. The
{Home} softkey is found in the MLControls display.
•
Takes a cue list to its last cue
•
[Go to Cue] [Shift] [Home] [Enter] homes the currently selected cue list to its last cue. The
{Home} softkey is found in the MLControls display.