ETC Element - User

140 Eos Family v2.9.0 Operations Manual
•
Off Time
•
Release Time
•
Record Confirm
•
Delete Confirm
•
Cue Only
•
Auto Playback
•
Plus %
•
Minus %
•
Level
•
Update Defaults (all)
•
Partition
•
Highlight
•
Lowlight
•
Highlight Remdim
•
Live Remdim Level
•
Preserve Blind
•
Encoder Degrees Per Rev
•
Encoder Percent Per Rev
•
Preserve Native (Patch Setting)
•
Gel Match Type (Color Picker Setting)
•
Gel Swatch Type (Color Picker Setting)
•
Popup Magic Sheet
•
Popup Nav Lock
User
This setup softkey accesses settings for a specific user. Changing these settings does not impact
other users on the network.
The following buttons are available in User settings:
•
Record Defaults (below)
•
Manual Control (on the facing page)
•
User Displays (on page142)
Record Defaults
Press {Record Defaults to enter this category.
Seven fields will be available to you: {Track}, {Record Confirm}, {Delete Confirm}, {Auto
Playback}, {Update Mode}, {Break Nested}, and {Update Last Ref}.
To change the setting for any of these fields, press the buttonin the CIA to activate it. If the field
requires data, enter it from the keypad. If the field is a toggle state, one press of the button will
switch the field to its other state.
Track
This field allows you to switch between tracking and cue only modes (see Tracking vs. Cue Only
(on page6) ). The default is “Tracking”.
Record Confirm
This setting allows you to enable/ disable the confirm action when storing over a previously
recorded target. The default is “Enabled”.