Show Control 427
Show Control Settings
In [Setup]>{System}>{Show Control}, you can adjust settings for MIDI Show Control, time code
(MIDI or SMPTE), analog, and serial functions. See
Show Control Setup (below)
Show Control Setup
This section allows you to adjust settings for MIDI show control, time code (MIDI or SMPTE),
analog, and serial functions. For more information on using show control with your system, see
About Eos Family Show Control (on the previous page)
Device Settings (Local MIDI/SMPTE)
{MIDI/SMPTE Rx}
Enables or disables the console's ability to locally receive MIDI or SMPTE. Defaults to
“Enabled."
{MIDI Tx}
Enables or disables the console's ability to locally transmit MIDI. Defaults to “Enabled."
{Time Code ID}
Sets the console's local Time Code ID.
{USBMIDI/SMPTE}
Enables or disables local USB connection to supported MIDI or SMPTEdevices. This setting must
also be enabled for Virtual MIDI devices.
SMPTE
{SMPTE Time Code Rx}
This button is used to control whether your console can receive SMPTE time code. Choosing
“Disabled” will disable all time code lists that have a SMPTE source. The default for this setting
is “Enabled”.
{Resync Frames}
This button allows you to configure how many frames need to be synced before time code starts
running. Frames can be from 1-30. Default is 2 frames.
MIDI - MSC
{MSC Receive}
This button toggles the setting for receiving MIDI Show Control from an external source between
“Enabled” and “Disabled”. The default setting is “Disabled”.
{MSC Transmit}
This setting, when enabled, allows the console to send MSC messages for actions taken on the
console, such as cue actions, macros firing, and submaster bumps. The default setting is
“Disabled”.
To Next Page
Loading...
