Using Park 305
[2] [At] [5] [0] [Park] [Enter] - parks channel 2 intensity at 50%
[2] {Intensity} [Park] [Enter] - parks the intensity of channel 2 at its current value
[2] [Park] [Enter] - parks all parameters of channel 2 at their current settings
Note: If a channel list is constructed in which some channels are parked and some
are unparked, [Park] [Enter] will unpark them all. A confirmation will be required.
[2] [At] [Park] [Enter] - if channel 2 is unparked, this command parks intensity at the
current value. If the intensity for channel 2 is parked, this command unparks intensity.
[2] [Color Palette] [8] [Park] [Enter] - parks the color for channel 2 in color palette 8.
[2] {Color} {Park} [Enter] - parks channel 2 color at its current value.
[Group] [Cue] [6] [Park] [Enter] - parks all the channels stored in cue 6 at their current
levels.
[Park] [Enter] - clears all parked channels and scaled park instructions (see
Scaled Parked
Values in Live
). A confirm is required. When a channel is unparked, it reverts to the level
the console is currently providing, or its default value if there is no current instruction. A
confirmation will be required.
You can use [Recall From] [Park] to set a channel or parameter to the same level as the current
park value. See
Recall From Park (on page256)
for more information.
Scaled Parked Values in Live
A scaled parked value allows the intensity output (only) to be modified proportionally in live.
Scaled park values are ignored when storing a record target. The setting on the display indicates
what should be stored, not the actual scaled value. An example of how to set a scaled parked
value in live includes:
[3] [At] [/] [1] [2] [5] [Park] [Enter] - sets a scaled value of 125% on channel 3 intensity. In
other words, whenever channel 3 is active, it will be active 25% higher than its current
setting.
[3] [At] [/] [8] [5] [Park] [Enter] - sets a scaled value for channel 3. Whenever channel 3 is
active, it will playback 15% lower than its current setting.
Remove the scaled parked value:
[3] [Park] [Enter] - unparks a scaled intensity for channel 3.
[Park] [Enter] - unparks all parked channels.
A channel can have both a scaled parked value and a parked intensity value. Keep in mind that
the parked intensity has priority over (and overrides) scaled park values.
Parked Addresses in Live
DMX addresses can be parked in Live. Below are some examples of parking an address in Live:
[Dimmer/Address] [5] [At] [5] [0] [Park] [Enter] - parks output 5 at 50% intensity.
[Dimmer/Address] [5] [Park] [Enter] - unparks output 5.
[[Dimmer/Address] [Park] [Enter] - unparks all parked outputs.
Park Values from the Park Display
You can park and unpark channel parameters or addresses from the park display. Open the
display by pressing [Park] [Park] or [Tab] [2] [0]. While in this display, it is assumed that you
want to park channels or parameters, therefore the use of the [Park] key is not necessary when
parking, but is used for unparking. You can also use [At] [Enter] to unpark.
To Next Page
Loading...
