ETC Element - Editing Presets in Blind

196 Eos Family v2.9.0 Operations Manual
Example:
If you want to store color data to color palette 4, press:
•
[Record]
and then press the button in the bank of color palette direct selects that is labeled in
the lower right corner with a light gray “4”.
•
{Color Palette Direct Select Button 4}
“Color Palette 4” will appear in the direct select, indicating a successful store.
For more information on direct select mapping, see Using Direct Selects (on page53) .
Using Filters with Palettes
Filters can be used to modify what data is stored to a palette by a record action. The parameters
that are active or filtered allow those parameters to be stored to record targets.
To filter a parameter:
1. Press the {Filter} button in the CIA. The {Filter} button will flash.
2. Press the touchbutton for the parameter you wish to store.
3. Press the {Filter} button to release. “Filter On” appears next to the parameter category
button.
To determine which parameter is filtered in the category:
1. Press the {Filter} button. All actively filtered parameters are highlighted in gray. You may
need to press the arrow softkey for that parameter category to page additional parameters
in the category.
Filters are a toggle state. To remove filters, press {Filter} and then press the highlighted
parameter buttons in the CIA to deactivate the filters, or use {Clear Filters}.
For more information on filters, see About Filters (on page250) .
Recalling Palettes
Intensity palettes can be selected from the control keypad or direct selects, and Focus, Color,
and Beam palettes can be selected from the Moving Light Controls (on page59) display or direct
selects.
Note: Pressing [Frame] [Frame] will post Color Palette to the command line.
When palettes are recalled, all data is manual and will display in red. Recalled palettes are
applied only to selected channels, therefore you must select channels before recalling a palette.
If a selected channel or parameter has no stored value in the recalled palette, it remains in its
current state. Palettes on direct selects will be highlighted if they are applicable for the current
channel selection.
You can select all the channels included in a palette by pressing [Group] {Palette} [x] [Enter].
You can also recall an entire palette by pressing [Recall From] {Palette} [x] [Enter].
Note: If enabled in Setup, you can double click on a palette direct select button to
quickly recall from the selected palette and put its content on stage. See Displays (on
page144) for additional information.