ETC Element - Recording and Editing Cues from Blind

238 Eos Family v2.9.0 Operations Manual
Example:
If you are currently in cue 5 and you want to update through cue 10, you would use the
following syntax:
•
[Update] [Thru] <Cue> [10] <CueOnly/Track> [Enter]
Update [+]
[+] can be used to specify a range of cues for updating. [+] can also be used with [Record] and
[Record Only].
Note: If no cue number is entered before the [+], the current active cue will be used.
Example:
To update only cues 5, 10, and 15:
•
[Update] <Cue> [5] [+] <Cue> [1][0] [+] <Cue> [1][5] <CueOnly/Track> [Enter]
To update the current cue and cue 7:
•
[Update] [+] <Cue>[7] <CueOnly/Track> [Enter]
Recording and Editing Cues from Blind
When you press blind, the selected cue will be displayed. You can make changes to cues in the
blind display using either the summary, table, or spreadsheet views.
CAUTION: Edits in blind take effect immediately. [Record] or [Update] commands
are not required in blind.
Note: To force blind to the selected cue, press [Blind] [Blind].
Move instructions can be removed from a cue by selecting the channel and pressing [At] [Enter].
This allows all values from the previous cue to track into the current cue. You can also use this
command for specific parameters as well.