ETC Element - Playback Status Display

System Basics 49
Flexichannel with Timing
You may also engage the “channels with timing” flexichannel state by pressing [Flexi] & [Time].
This will display all channels that have discrete timing in the current cue and will remove
channels without discrete timing from view.
The display will remain in this state until you disengage it by pressing [Flexi] again.
About & Display Toggles
While in Live/Blind, you can use the [About] key to view additional information.
When in an [About] mode, the mode type will display in the upper left hand corner of the Live/
Blind display.
The following is a list of the [About] modes available in the Live/ Blind displays:
Note: Hold [About] and double tap the modifier key to latch the mode.
•
[About] & [Live] - displays the DMX levels.
•
[About] & [Data] - displays the background level information.
•
[About] & [Park] - displays the parked levels.
•
[About] & [Part] - displays the cue part number for each parameter.
•
[About] & [Cue] - displays the source target type and number. For cues, the cue list and
cue number that contained the last move will display.
•
[About] & [Mark] - displays the mark cue used by the channels.
•
[About] & [Next]/[Last] - displays the next cue with that the channels move in or the last
cue with that the channels moved in.
•
[About] & [Label] - displays the reference labels.
•
[About] & [Time] - displays the discrete time.
•
[About] & [Path]/{Color Path} - displays the color paths.
Note: To page while in these modes, release the modifier key while keeping [About]
held down.
Playback Status Display
The playback status display (PSD) allows you to view a range of cues in the cue list and all the
cue attributes for those cues.
The PSDopens on Tab 2. This display cannot be closed, but you can have multiple instances of
the PSDopen on different tabs.
Holding down [Time] , while a cue is fading, will display the cue category times counting down
in the cue list display area. The default action is to show the total time not the countdown.
To always show the countdown, a {PSD Time Countdown} option is available in PSD
configuration menu (see Playback Status Display Configuration (on page52) ). When the {PSD
Time Countdown} is enabled, the cue category times will countdown as a cue is fading. To see
the total time, hold down the [Time] key. {PSD Time Countdown} is “disabled” by default.
An optional command line for the playback status display is available. The optional command
line must be enabled to use. See Playback Status Display Configuration (on page52) .