Storing and Using Submasters 317
Freeze and StopEffect on Submasters
Freeze
[Live] {Fader Control} {Freeze} can be used to halt all effect activity on any active submaster. To
activate a freeze for only a specific submaster, press [Live] {Fader Control} {Freeze} & [Load].
There are two ways to remove the freeze command:
Press {Freeze} & [Load] again for the specific faders to unfreeze the activity.
Press [Assert] & [Load] or [Go] or [Stop/Back] for the specific faders to resume the activity.
StopEffect
The [Live] {Fader Control} {Stop Effect} button can be used to stop all effects from operating on
any or all faders, or it may be used with the control keypad to stop a specific effect.
To stop all effects on a fader, press {Fader Control} {Stop Effect} & [Load] of the associated
fader.
To stop a specific effect regardless of the fader it is operating on, press [Effect] [2] {Fader
Control} {StopEffect} [Enter].
When an effect is stopped, all impact of the effect is removed and the stage output is as though
the effect had never been activated.
Moving and Copying Submasters
You can move a submaster using Move To. Press [Copy To] twice to put Move To on the
command line.
Example:
[Sub] [2] Move To [Sub 9] [Enter][Enter] - moves the contents, label, and timing
data from submaster 2 and places it in submaster 9. Submaster 2 is removed.
You can copy the contents of a submaster by using the [Copy To] button.
[Sub] [2] [Copy To] [Sub 9] [Enter][Enter] - copies the contents, label, and timing data
from submaster 2 and places it in submaster 9.
[Sub] [2] [Copy To] [Sub 9] {Attrs Only} [Enter][Enter] - copies all of the submaster
properties from submaster 2 and places it in submaster 9. Levels, effects, and labels are
not copied when using the {Attrs Only} softkey.
[Sub] [2] [Copy To] [Sub 9] {Labels Only} [Enter][Enter] - copies only the label from
submaster 2 and places it in submaster 9.
Releasing Content From a Submaster
To release content from a submaster, use one of the following methods:
{Fader Control} {Off} & [Load]- stops any running effects and fades out according to the
{Restore} mode of the submaster.
{Fader Control} {Release} & [Load] - behaves in the same way as {Off}. {Release} no longer
unmaps the fader.
[Shift] & [Load] - behaves like {Off} and {Release} except that it will also unmap the fader.
Updating a Submaster
It is possible to make changes to a submaster in Live mode. [Update] is used to store changes to
a submaster.
To Next Page
Loading...
