ETC Element - About Effects; The Effect List

268 Eos Family v2.9.0 Operations Manual
Using [Go]
The [Go] button is used to execute the pending cue. When [Go] is pressed, all parameters
assume their required positions in the recorded times, unless they have been recorded with
manual timing.
For information on manual timing, see Manual Timing Control (on page270) and for manual
master, see Master (on page245) .
Using [Stop/ Back]
When a cue is complete, pressing [Stop/Back] will step backwards sequentially through the cue
list from that point. [Stop/Back] uses default back time as established in Setup, see Manual
Control (on page141) . Or you can back into the previous cue using specific timing by pressing:
•
[Go to Cue] [Last] [Time] [n] [Enter]
Using Blackout and Grandmaster
The grandmaster inhibits all live intensity values. If the grandmaster is set at 50%, all live
intensities will be at 50% of their actual values.
Blackout sets all lighting levels to zero.
When a grandmaster or blackout are active, a grandmaster/ blackout warning will display at the
top of all monitors. Clicking that will open a dialogue in the CIA.
For more information, see Grandmaster and Blackout (on page14) .
[Go To Cue] [0]
You can use the [Go To Cue] [0] [Enter] command to send the cue list to cue 0. This drives all
cue intensities to zero, while leaving non-intensity parameters as currently set but no longer
under cue control.
Using Assert (Playback Button)
Use [Live] {Fader Control} {Assert} & [Load] for the master fader pair to re-run the active cue in
that fader, following the same rules as [Go To Cue]. Assert can be used to regain control of all
cue contents, or make any changes in Blind to an active cue on stage.
When [Live] {Fader Control} {Assert} & [Load] are used together, the entire contents of the cue
are replayed.
Using Timing Disable
The [Live] {Fader Controls} {Time Disable} button, used with [Load], causes timing data to be
ignored for any cues that are activated on the playback fader. When the playback fader is in
timing disable mode, you will notice a red “TD” in the PSD.
To release the playback fader from time disable mode, press {Fader Controls} {Time Disable} &
[Load] again. You can also cut the next cue in by pressing {Fader Controls} {Time Disable} & [Go]
or the last cue by pressing{Fader Controls} {Time Disable} & [Back].
Note: [Shift] & [Go] and [Shift] & [Back] can be used to cut to the next cue in the
same way as [Timing Disable] & [Go] and [Timing Disable] & [Back].