Cue Playback 271
control is released from the fader when the cue is considered complete (when the fader is
brought back to 100%). If the fader is set as an Intensity Master, the intensity control is
maintained, even when the cue has completed.
If a pending cue has any manual control properties, you may either preset the fader to zero or
the console will automatically set the fader to zero when the [Go] button is pressed.
Manual intensity override is not possible if there is any manual timing in the cue, as the fader is
already occupied with that control.
Manual Override
Manual override allows the master fader pair to control all parameters in a transition state.
When [Live] {Fader Controls} {Man Override} & [Load] are pressed, all activity on the fader pair
is frozen.
The faders can then be used to manually complete the cue transition for all parameters.The left
fader controls the intensity upfade and all non-intensity parameters, while the right fader
controls all intensity downfade actions. Manual control override automatically releases when
the cue is complete.
Releasing Content From a Fader
There are a few ways to release content from a playback fader:
{Off} & [Load] - returns control to the background fader, either a cue or a submaster, and
stops any effects that are running on that fader. If there is no background value, the
intensities will just fade out. Press {Fader Control} to see {Off}.
Note: Associated pending and current cues will remain when using {Off} & [Load].
Note: Pressing [Go] will run the cues in their current sequence.
{Release} & [Load] - behaves like {Off} & [Load] except that it sets the pending cue to the
first cue in the list and removes the active cue. Press {Fader Control} to see {Release}.
[Shift] & [Load] - behaves like Release & [Load] except that it additionally removes the
content entirely from the fader. Pressing [Shift] & [Load] on an empty playback fader will
unmap the fader.
[Escape] & [Load] - unmaps all instances of the target (cue list, submaster, palette, or
preset) on a selected fader.
The [Go To Cue] [Out] [Enter]command can be used to fade out all intensities, reset all cue lists
to the top, and to clear out all background LTP fader values.
To Next Page
Loading...
