240 Eos Family v2.9.0 Operations Manual
Editing From the Blind Spreadsheet
The blind spreadsheet is another useful blind view of cue data. While in blind, press [Format] to
access the spreadsheet. See
Spreadsheet (Blind Only) (on page40)
for more information.
In spreadsheet view, cues are listed on the y axis and channels/ parameters are displayed on the
x axis. This view is useful for showing a limited number of channels over a span of numerous
cues. This is the only view where channel data of multiple cues can be viewed at once. This
makes spreadsheet view useful for viewing overall trends in channel and parameter data.
Pressing [Data] & {parameter tiles} will expand or collapse information shown.
Editing cue ranges is possible in spreadsheet view. To select all of the cues, you can press [Cue]
[Home] [Thru] [Enter].
Replace With
{Replace With} is used to select channels that have certain specified values and then provide
new instructions for those values.
Example:
Select a range of cues:
[Cue] [1] [Thru] [9] [Enter]
Select a range of channels that are used throughout these cues and enter a change
instruction:
[1] [Thru] [7] <At> [Color Palette] [5] {Replace With} <Color Palette> [3] [Enter]
This instruction finds all instances of channels 1 through 7 in cues 1 through 9 that are
in color palette 5 and replace Color Palette 5 with Color Palette 3. Be aware of the
track/ cue only settings when using this command.
Note: [Cue] {Home} [Thru] [Enter] will select all stored cues. [Thru] [Enter] can be
used with all record targets. See Home (on page164) for information about accessing
the {Home} button.
The range of possibilities of potential {Replace With} commands is virtually endless and can be
applied to single cues or channels, ranges of cues or channels, parameters of any type, or timing
data.
Move To
Move Tois used to move cues from one location in a cue list to another location in the list.
Note: To put Move To on the command line, press [Copy To] twice.
When cues are moved, values that were tracks or move instructions and now match the previous
cue will be auto-blocked by the system. The impact on subsequent cues is based on track/cue
only settings as described above. Below is an example of Move To:
[Cue] [2] Move To <Cue> [9] [Enter] - the contents of cue 2 moves to cue 9. Cue 2 is
deleted. If cue 9 already existed, a confirmation will be required (unless confirmations
have been disabled in setup). Any contents of cue 9 will be replaced entirely.
To Next Page
Loading...
