412 Eos Family v2.9.0 Operations Manual
Obtain an IP Automatically
Note: ETC recommends the use of a static IP address for compatibility with other ETC
devices, though the needs of your particular installation may vary.
Clicking in the enable box will set the desk to get its IP address dynamically from a DHCP server.
While the desk is starting, it will ask for an IP address from a DHCP server. If one responds, it
will use the assigned IP address.
If no DHCP server is available, the desk will default to a self-generated link-local IP address in
the range of 169.254.x.y. The IP address used by the desk in this configuration may change
dynamically as needed. A change should typically only occur when there are changes to the
network configuration or to resolve an IP address conflict.
Enabling or disabling the DHCP setting will require you to reboot the desk for the new setting to
take affect.
Note: You cannot set the desk to receive an IP address via DHCP and act as a DHCP
server at the same time. It can either send dynamic addresses or receive them, but not
both at the same time.
IP Address
If DHCP is disabled, you set the IP address here. This is a static IP address and will remain set
until changed by a user.
The following is a list of the default IPaddresses:
Console Port 1 Port 2
Eos 10.101.90.101 NA
Eos RPU 10.101.95.101 NA
RVI 10.101.85.101 NA
Eos Ti 10.101.92.101 192.168.92.101
Gio 10.101.91.101 192.168.91.101
Gio @ 5 10.101.98.101 192.168.98.101
RPU3 10.101.93.101 192.168.93.101
RVI3 10.101.86.101 192.168.86.101
Ion 10.101.100.101 NA
Ion Xe 10.101.100.20 192.168.100.20
Ion Xe 20 10.101.100.30 192.168.100.30
Ion Xe RPU 10.101.96.201 192.168.96.201
Element 10.101.97.101 NA
Element 2 10.101.99.101 192.168.99.101
If DHCP is enabled, this field will display the IP address that is being used by the desk (whether it
is served via DHCP or a self-generated link-local IP address).
Subnet Mask
If DHCP is disabled, you set the subnet mask here. This is a static setting and will remain set
until changed by a user. The default subnet mask is 255.255.0.0.
If DHCP is enabled, this field will display the subnet mask that is being used by the desk
(whether it is served via DHCP or a self-generated link-local IP address).
To Next Page
Loading...
