ETC Element - Page 462

450 Eos Family v2.9.0 Operations Manual
Cue Data Field List Data Field Action
Cue - Runs the specified cue in cue list 1
- List Runs the next cue in the specified list
- - Runs the next cue in cue list 1
Stop
When accompanying a MIDI “Stop” command, data for the following fields will result in the
following actions:
Cue Data
Field
List
Data
Field Action
Cue List Stops the specified cue & list (if running)
Cue - Stops the running cue in cue list 1
- List Stops the current cue from the specified list
- -
Stops the running cue on the master fader of the console that received
the command
If a cue is not currently running (or already stopped), the Stop command will trigger Back, fading
back to the previous cue.
Resume
When accompanying a MIDI “Resume” command, data for the following fields will result in the
following actions. If there are no stopped cues, this action is ignored.
Cue Data Field List Data Field Action
Cue List Resumes the specified cue & list (if stopped)
Cue - Resumes the specified cue in the default cue list
- List Resumes the current cue in the specified list
- - Resumes all stopped cues
Set
The “Set” command allows MSC to control specific faders using both a numeric control value
(which specifies the fader number) and a data field (which controls the level: 0-100). Control
values are as follows:
Control Value Data Field Indication
1-127 0-100 Submaster 1-127
128 0-100 Primary playback in
129 0-100 Primary playback out
510 0-100 Grandmaster
All other control values are ignored.
Note: See Hexadecimal and MIDI Show Control Formatting for information on
formatting MIDI messages.
Fire
This command fires a macro. MSC supports macros 1 through 127 only. Therefore a numeric
value of 1 through 127 followed by 00 (in hex) would accompany this command.