ETC Element - Page 498

486 Eos Family v2.9.0 Operations Manual
Cue List Banks
Note: <index> is a 1-based index of any number of OSC cue list banks you wish to
create. Eos will send the cue list label and cue information for all OSC cue list banks.
See Explicit OSC Output for more information.
OSCMethod Arguments Examples/Comments
/eos/cuelist/<index>/config/<cue
list number>/<num prev
cues>/<num pending cues>
/eos/cuelist/1/2/3/6 (create OSC cue list bank
#1 for cue list 2, showing 3 previous cues, the
current cue, and 6 pending cues)
NOTE: set <cue list number> to zero to follow
the current cue list
/eos/cuelist/<index>/config/<cue
list number>/<num prev
cues>/<num pending cues>/<off-
set>
/eos/cuelist/1/2/3/6/10 (create OSC cue list
bank #1 for cue list 2, showing 3 previous
cues, the current cue, and 6 pending cues,
starting at offset 10 into the cue list) offset is
a zero-based index into the entire cue list,
where each cue counts as one item and each
cue part counts as one item
NOTE: set <cue list number> to zero to follow
the current cue list
/eos/cuelist/<index>/page/<delta>
/eos/cuelist/1/page/1 (page OSC cue list bank
down 1 row)
/eos/cuelist/1/page/-1 (page OSC cue list
bank up 1 row)
/eos/cuelist/1/page/0 (jump back to the
current cue and follow it)
/eos/cuelist/<index>/select/<cue
number>
/eos/cuelist/1/select/100.4 (jump to cue
100.4)
Softkey
Note: <index> is 1-based index into the softkey list. There are 6 softkeys and 2
pages, so valid <index> numbers are 1-12.
OSCMethod Arguments Examples/Comments
/eos/softkey/<index>
number for button edge: 1.0=down, 0.0-
0=up (optional)
/eos/softkey/1=1.0 (press 1st
softkey)
/eos/softkey/1=0.0 (release
1st softkey)
Other Targets - Selection
OSC Method Arguments Examples/Comments
/eos/curve number of curve to select /eos/curve=1
/eos/fx number of effect to select /eos/fx=1
/eos/snap number of snapshot to recall /eos/snap=1
/eos/pixmap number of pixel map to select /eos/pixmap=1