Fuji Xerox DocuCentre SC2020

Understanding the Machine Menus
181
Tools
9
Values:
 Initialize Print Meter
Purpose:
To initialize the print meter of the machine. When the print meter is initialized, the meter
count is reset to zero.
Value:
 Non-Genuine Toner
Purpose:
To use toner cartridge of another manufacturer.
Note • Using a non-Fuji Xerox toner cartridge may severely damage the machine. The warranty does not
cover damages caused by using non-Fuji Xerox toner cartridges.
Values:
 Adjust Altitude
Purpose:
To specify the altitude of the location where the machine is installed.
The discharge phenomenon for charging the photo conductor varies with barometric
pressure. Adjustments are performed by specifying the altitude of the location where the
machine is being used.
Note • An incorrect altitude adjustment setting leads to problems such as poor printing quality and
incorrect indication of remaining toner.
Values:
 Clear Job History
Purpose:
To clear the job history of all finished jobs.
 Adjust TouchScreen
Purpose:
Fax Settings Initialize Initializes the fax number entries in the
Address Book.
Scan Settings Initialize Initializes the e-mail and server address
entries in the Address Book.
System Settings Initialize Initializes the system parameters.
Initialize Initializes the print meter.
Off Does not use toner cartridge of another manufacturer.
On Uses toner cartridge of another manufacturer.
0 m Sets the altitude of the location where the machine is installed.
1000 m
2000 m
3000 m
4000 m
5000 m