● Open the booklet fully and load it in the ADF paper chute (feeder). Otherwise, the booklet may not be fed.
● When scanning a booklet, press the [Manual Feed] button to switch the feed mode to Manual Feed Mode.
If you started a scan but did not switch the feed mode to Manual Feed Mode, close the ADF, open it again,
and then switch the feed mode to Manual Feed Mode.
The setting for switching the feed mode to Manual Feed Mode can also be configured in the scanner driver.
● Dirty rollers may cause feeding errors or dirt to get on a booklet.
Clean the rollers frequently.
For details about cleaning, refer to Daily Care (page 214).
● If there is dirt on the front or back side of a booklet, such as grease marks (fingerprints), wipe the dirt off
then perform a scan.
● If you do not want a booklet to become dirty or damaged, use the optional Booklet Carrier Sheet.
● If an attachment such as a VISA is attached to a page (a side to be scanned) of an open booklet, it is
recommended to use the optional Booklet Carrier Sheet.
● When using the Booklet Carrier Sheet, configure the scan settings for the Booklet Carrier Sheet in the scanner
driver, and perform a scan.
How to Load Documents
122
To Next Page
Loading...
