Fujitsu fi-8170

Example:
Outside of the document may have been scanned because the scanned document is shorter than the specified
paper size.
In this case, take one of the following measures, and then scan again.
● Load a document of the specified paper size in the ADF paper chute (feeder).
● Change the scan settings so that the scanning area is set inside of the document.
ATTENTION
Ways to designate the scanning area differ depending on scanner drivers and image scanning applications.
For details, refer to the help for your scanner driver and the manual/help for your image scanning
application.
Imprinting Area Error (When the Imprinter Is Installed) [fi-8190/fi-8170/fi-8150/
fi-8150U]
If an error occurs with the print start position in the imprinter, the following is displayed on the operator panel.
● For the LCD
An error code, error details, and a solution for the problem are displayed on the LCD.
Troubleshooting
278