Fujitsu fi-8170

Wired LAN
Set an IPv4 address or IPv6 address for the scanner.
Click [Wired LAN] in [Network] to display the window.
ATTENTION
An IPv6 address is not supported when the scanner is operated with PaperStream NX Manager.
IPv4 Configuration
Set an IPv4 address.
● Auto
This is the factory default setting.
● Manual
When [Manual] is selected, specify the following items:
- IP Address
- Subnet Mask
- Default Gateway
DNS Server
Set a DNS server.
● Auto
This is the factory default setting.
● Manual
When [Manual] is selected, specify the following items:
- Primary DNS
- Secondary DNS
IPv6 Configuration
Set an IPv6 address.
● Auto
This is the factory default setting.
● Manual
When [Manual] is selected, specify the following items:
- [Receive RA packet] check box
Select the [Receive RA packet] check box to enable an IPv6 address that has been generated
automatically.
You can check an IPv6 address that has been generated automatically in the [Scanner Information]
window.
The check box is selected for the factory default setting.
- IP Address
Network Settings (fi Series Network Settings) [fi-8190/fi-8290/fi-8170/fi-8270/fi-8150/fi-8250]
408