Operational Procedure [fi-8150/fi-8250/fi-8150U/fi-8250U]
1 When overlapped documents are detected, "J" and "2" are displayed alternately on the Function
Number Display.
2 Follow each instruction below depending on the operation mode that is selected.
● Standard mode/Manual mode
Scanning will stop immediately when overlapped documents are detected. Either press the [Send to]
button to eject the document from the paper path, or open the ADF to remove the document. Then load
the overlapped documents back in the ADF paper chute (feeder).
For more details about opening the ADF, refer to How to Open the ADF (page 77).
When the ADF is open, it might close accidentally. Be careful not to get your
fingers caught.
After removing the documents while the ADF is open, close the ADF.
For more details about closing the ADF, refer to How to Close the ADF (page 78).
Be careful not to get your fingers caught when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, documents may not be fed into the ADF.
Note that if the setting for stopping the scan to check images is set to on in the scanner driver, scanning
will stop after overlapped documents are ejected so press the [Send to] button and load the overlapped
documents back in the ADF paper chute (feeder).
● Auto mode 1/Auto mode 2
Scanning will stop after overlapped documents are ejected so press the [Send to] button and load the
overlapped documents back in the ADF paper chute (feeder).
3 When documents are ejected, the function number flashes on the Function Number Display.
4 Operate the scanner as follows, and restart scanning.
Note that the function number flashing speed switches between [slower] ↔ [faster] every time you press the
[Function] button.
What the [slower] and [faster] statuses indicate for the function number flashing speed is described below.
● What the [slower] status indicates
Detecting a multifeed for the next document is enabled. Or, memorizing an overlap pattern is disabled.
● What the [faster] status indicates
Detecting a multifeed for the next document is disabled. Or, memorizing an overlap pattern is enabled.
Make sure that the function number is flashing in the [faster] status and press the [Scan/Stop] button or start
scanning from the computer.
When the function number is flashing in the [faster] status, the scanner operates in each mode as follows:
Various Ways to Scan
210
To Next Page
Loading...
