Cleaning the Inside of the Scanner (ADF) with Cleaning Paper
The inside of the ADF can be cleaned with a sheet of Cleaning Paper moistened with Cleaner F1.
As the scanner continues to feed the documents, paper dust will accumulate inside the ADF and it may cause
problems related to scanning or affect the scanned results. Cleaning should be performed approximately every
5,000 sheets scanned. Note that this guideline varies depending on the types of documents you scan. For instance,
it may be necessary to clean the scanner more frequently when you scan documents on which the toner is not
sufficiently fused.
ATTENTION
● Do not use water or mild detergent to clean the ADF.
● It may take a long time to dry if an excessive amount of Cleaner F1 is used. Use only a small amount.
1 Turn on the scanner.
For details, refer to How to Turn the Power ON (page 72).
● For fi-8190/fi-8290/fi-8170/fi-8270
When the [Ready] screen is displayed on the LCD, proceed to step 2.
● For fi-8150/fi-8250/fi-8150U/fi-8250U
When "1" is displayed on the Function Number Display, proceed to step 5.
2 Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3 Press the [ ]/ [ ] button to select [3: Cleaning], then press the [Scan/Enter] button.
The [Cleaning] screen is displayed on the LCD.
4 Press the [
]/ [ ] button to select [1: Cleaning Paper], then press the [Scan/Enter] button.
A message is displayed on the LCD.
ATTENTION
Do not start scanning with an image scanning application during cleaning.
5 Spray the Cleaning Paper with Cleaner F1.
6 Pull out the chute extensions according to the length of the Cleaning Paper.
For details, refer to Setting Up the ADF Paper Chute (Feeder) (page 81).
7 Adjust the stacker according to the length of the Cleaning Paper.
For details, refer to Setting Up the Stacker [fi-8190/fi-8170/fi-8150/fi-8150U] (page 82) or Setting Up the
Stacker [fi-8290/fi-8270/fi-8250/fi-8250U] (page 87).
Daily Care
219
To Next Page
Loading...
Need help?
General
Weight and Dimensions
