Fujitsu fi-8170

Operation Mode Description
Note that if the setting for stopping the scan to check images is
set to on in the scanner driver, scanning will stop after
overlapped documents are ejected.
Auto mode 1 Specify the setting not to automatically detect overlapped
documents when the paper attachment is the same length and
in the same location as memorized.
Scanning will stop after the overlapped documents are ejected.
In this operation mode, up to four overlap patterns can be
memorized at a time (when one sheet is scanned), and up to 32
overlap patterns can be memorized in total.
When the 33rd overlap pattern is detected, the first pattern that
was memorized is overwritten.
However, when turning the scanner off and on, the number of
memorized overlap patterns depends on the setting for
[Remember overlap patterns at power-off] in the Software
Operation Panel.
For details, refer to Setting to Ignore Certain Overlap Patterns
[Intelligent Multifeed Function] (page 386).
Auto mode 2 Specify the setting not to automatically detect overlapped
documents when the paper attachment is the same length or
shorter as memorized.
Scanning will stop after the overlapped documents are ejected.
Only one overlap pattern can be memorized in this operation
mode.
Select an operation mode.
● For fi-8190/fi-8290/fi-8170/fi-8270
Use one of the following methods to select an operation mode.
- Select an operation mode in [14: iMFF Setting] on the [Settings Menu] screen of the operator panel.
For details, refer to How to Use Settings Menu (page 146).
- Select the operation mode in the Software Operation Panel.
For details, refer to Setting to Ignore Certain Overlap Patterns [Intelligent Multifeed Function] (page 386).
● For fi-8150/fi-8250/fi-8150U/fi-8250U
Select the operation mode in the Software Operation Panel.
For details, refer to Setting to Ignore Certain Overlap Patterns [Intelligent Multifeed Function] (page 386).
Operational Procedure [fi-8190/fi-8290/fi-8170/fi-8270]
1 When overlapped documents are detected, the following is displayed on the LCD:
When Overlapped Documents Are Detected
Multifeed detected (Overlap)
Various Ways to Scan
206