Scanning Photographs and Clippings without Damaging Them
Using the optional Carrier Sheet or Photo Carrier Sheet allows you to scan non-standard size documents such as
photographs or clippings without damaging them.
The procedure to perform a scan with the Photo Carrier Sheet is described as an example below.
1 Place a document inside the Photo Carrier Sheet.
Open the Photo Carrier Sheet and centrally place the top end of the document against the side with a black
and white pattern of the Photo Carrier Sheet.
Note that the front side of the Photo Carrier Sheet has a black and white pattern at the top and a thick
vertical line in the upper right-hand corner.
2 Load the Photo Carrier Sheet with the end with the black and white pattern as the leading edge and
with the scanning side facing the ADF paper chute (feeder) (face-down).
Secure the Photo Carrier Sheet with the side guides to avoid skewing.
3 Configure the scan settings in the scanner driver to use the Photo Carrier Sheet.
For details, refer to the help for the scanner driver.
4 Scan the document with the image scanning application.
For details, refer to the manual/help of the image scanning application.
ATTENTION
● The image printed on the document is cropped and it is pasted in the center of a blank image. The size of a
blank image is the size specified for [Paper Size] in the scanner driver.
Various Ways to Scan
193
To Next Page
Loading...
