An alphabetical character and a number for the error code are displayed alternately on the Function Number
Display.
Error Code Error Details (displayed in the Error Recovery Guide window)
J8 Sensor(s) dirty
Take the following measures.
● Clean the document sensors by referring to Cleaning the Inside of the Scanner (ADF) with a Cloth (page 222).
● Turn the scanner off then back on.
If the problem still persists, write down the error code, check each item in Before You Contact the Scanner
Service Provider (page 330) and then contact the distributor/dealer where you purchased this product. Refer to
the contact information in the Contact List if supplied with this product, or refer to the contact information in
the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
Sensor Error
If a sensor error occurs, the following is displayed on the operator panel.
● For the LCD
An error code, error details, and a solution for the problem are displayed on the LCD.
Error Code Error Details and the Solution
L0:11 L0:11 Error
Sensor error
Turn the power back on. If the problem persists, refer to the Operator's
Guide and take measures accordingly.
L2:13 L2:13 Error
Sensor error
Turn the power back on. If the problem persists, refer to the Operator's
Guide and take measures accordingly.
L5:17 L5:17 Error
Sensor error
Turn the power back on. If the problem persists, refer to the Operator's
Guide and take measures accordingly.
L5:18 L5:18 Error
Sensor error
Turn the power back on. If the problem persists, refer to the Operator's
Guide and take measures accordingly.
L6:1B L6:1B Error
Sensor error
Turn the power back on. If the problem persists, refer to the Operator's
Guide and take measures accordingly.
● For the Function Number Display
Troubleshooting
267
To Next Page
Loading...
