Settings Related to Sheet Counters
Checking the Sheet Counters
The status of each consumable part can be viewed to determine when to replace or clean the consumables.
The background color of the counter changes as it gets closer to the time to replace the consumables or to clean the
scanner.
The color of each counter changes as follows:
● [Brake Roller]/[Pick Roller] counters
These counters turn light yellow when the sheet count after the consumable replacement reaches 95% of the
value specified in Specifying the Cycle to Replace Consumables [Life Counter Alarm Setting] (page 358) in the
Software Operation Panel, and turn yellow when the sheet count reaches 100%.
● [After cleaning] counter
This counter turns yellow when the sheet count after cleaning reaches the value specified in Scanner Cleaning
Cycle [Cleaning Cycle] (page 357) in the Software Operation Panel.
● [Remaining Ink] counter
This counter turns yellow when the amount of remaining ink reaches below 33% (only displayed when the
imprinter is installed).
1 Start up the Software Operation Panel.
For details, refer to Starting Up the Software Operation Panel (page 333).
2 From the list on the left, select [Device Setting].
Scanner Settings (Software Operation Panel)
352
To Next Page
Loading...
