Precautions
● Notes on the documents to be scanned
Depending on the documents to be scanned, take note of the following.
● Since carbonless paper contains chemical substances that may harm the rollers such as the brake roller and
pick roller, take note of the following:
- Cleaning
If paper jams occur frequently, clean the brake roller and pick roller.
For details, refer to Daily Care (page 214).
- Replacing the consumables
The life of the brake roller and pick roller may end sooner compared to scanning wood-free papers.
● When scanning wood containing papers, the life of the brake roller and pick roller may end sooner compared
to scanning wood-free papers.
● The brake roller and pick roller may be damaged when a photo/sticky note on a document comes into contact
with these parts during scanning.
● The surface of the document may be damaged when gloss papers such as photographs are scanned.
For documents that can be damaged quite easily, use the optional Carrier Sheet or Photo Carrier Sheet.
● The light of the LED may reflect brightly when glossy papers are scanned.
● When scanning semi-transparent documents, set [Brightness] higher in the scanner driver to avoid bleed-
through.
● When you scan documents written in lead pencil, there may be black traces left on the document, which may
cause feeding errors.
Clean the rollers frequently.
For details about cleaning, refer to Daily Care (page 214).
● If documents are not fed, or documents are fed overlapped or jammed frequently, refer to Troubleshooting
(page 283).
● When you scan documents with the ADF, all the documents must be flat on the leading edge.
Make sure that curls on the leading edge of the documents are kept within the following range.
● Notes on plastic cards
When you scan plastic cards, take note of the following.
● Make sure you use a card that meets the following specifications, and check if the card can be fed before
scanning it.
How to Load Documents
120
To Next Page
Loading...
