Fujitsu fi-8170

How to Perform a Basic Scan
This section explains how to perform a basic scan.
ATTENTION
Depending on the connection method of the scanner, use only the USB cable to connect to a computer or use
only a LAN cable to connect to a network device. Do not use both cables at the same time.
HINT
When scanning with the scanner connected to a network, because the image transfer speed is prioritized, the
image quality is lower than when scanning with the scanner connected via a USB cable.
In the scanner driver, you can set the image quality to the same level as the level that is set when scanning with
the scanner connected via a USB cable. For details, refer to the help for the scanner driver.
● Operating with a Computer
Start scanning with one of the following methods.
● Performing a Scan with an Image Scanning Application (page 95)
● Pressing a Button on the Scanner in order to Start an Image Scanning Application and Perform a Scan (page
97)
● Operating with PaperStream NX Manager
Start scanning with the following method.
● Processing a Job (With PaperStream NX Manager) [fi-8190/fi-8290/fi-8170/fi-8270] (page 106)
● Processing a Job (With PaperStream NX Manager) [fi-8150/fi-8250] (page 110)
ATTENTION
Note that scanners operated with PaperStream NX Manager cannot be operated by a computer.
93