Configuring Not to Detect Certain Overlap Patterns
If detecting overlapped documents during a scan is set, when you scan a document with a paper attachment
such as a sticky note, receipt, or photo, it is detected as overlapped documents, and the scan may stop. Use the
intelligent multifeed detection function not to detect these types of documents.
This function has two modes, a mode that is used to configure the settings manually by a user every time the
scanner detects overlapped documents, and a mode that is used to configure the settings automatically by the
scanner based on the overlap patterns (length and location) for paper attachments such as sticky notes,
receipts, or photos that the scanner has memorized.
To use this setting, detecting overlapped documents needs to be set in advance.
● [Multifeed Detection] in the scanner driver
For details, refer to the help for the scanner driver.
● [Multifeed] in the Software Operation Panel
For details, refer to Specifying a Method to Detect Overlapped Documents [Multifeed] (page 378).
The following four operation modes are available.
Operation Mode Description
Standard mode Specify whether or not to detect overlapped documents every
time they are detected.
Overlapping is not detected for a piece of paper (80 mm or less
in the feeding direction) attached on a document (such as sticky
notes).
Scanning will stop immediately if overlapped documents are
detected.
Note that if the setting for stopping the scan to check images is
set to on in the scanner driver, scanning will stop after
overlapped documents are ejected.
Manual mode Specify whether or not to detect overlapped documents every
time they are detected.
Scanning will stop immediately if overlapped documents are
detected.
Various Ways to Scan
205
To Next Page
Loading...
