3 Scan the document with the image scanning application.
For details, refer to the manual/help of the image scanning application.
After scanning is started or a document is ejected, the scanner will wait for documents to be loaded in the
ADF paper chute (feeder) until the timeout time elapses.
In Manual Continuous Mode, the rollers inside the ADF keep rotating.
In Manual Feed Mode, the rollers inside the ADF do not rotate.
4 Load the next document in the ADF paper chute (feeder).
5 Repeat step 4 until all documents are scanned.
6 Finish scanning.
Scanning will stop if no document is loaded within the timeout time after the last document is ejected.
To immediately stop scanning, press the following button depending on the scanner.
● For fi-8190/fi-8290/fi-8170/fi-8270
[Stop/Clear] button
● For fi-8150/fi-8250/fi-8150U/fi-8250U
[Send to] button
HINT
● When you press the [Manual Feed] button to switch the feed mode to Manual Feed Mode, after scanning is
complete, Manual Feed Mode is cleared.
If you want to scan more than one document in succession in Manual Feed Mode, select [Continue] for [Manual
Feed Mode] in the Software Operation Panel.
When [Continue] is selected for [Manual Feed Mode], documents are scanned in succession in Manual Feed
Mode until the [Manual Feed] button is pressed.
For details, refer to Waiting Time in Manual Feeding [Manual Feeding] (page 388).
● If you use manual feeding frequently, the replacement cycle of the consumables may be shortened.
Various Ways to Scan
204
To Next Page
Loading...
