Place the document face-down to align its top left-hand corner with the reference point.
4 In the scanner driver, configure the scan settings for the flatbed.
For details, refer to the help for the scanner driver.
5 Scan the document with the image scanning application.
For details, refer to the manual/help of the image scanning application.
Do not look at the light source directly during scanning.
ATTENTION
● Do not move the document during scanning.
● If glare from interior light gets caught in a scanned image, it may not be output in the actual size it was
scanned in.
Place your scanner in a place where it is not affected by interior light.
In the scanner driver, you can configure the settings for removing ambient light.
For details, refer to the help for the scanner driver.
6 Attach the document cover.
7 Close the document cover.
For details, refer to How to Close the Document Cover (page 80).
Various Ways to Scan
199
To Next Page
Loading...
Need help?
General
Weight and Dimensions
